| POD VERSION 1.x IS DIFFERENT FROM POD VERSION 2.1 |
-- 4 more amp models - Line6 Twang, Crunch#2, Blues, and Insane.
-- The Marshall off axis cab sim went away and was replaced with a Marshall w/greenbacks.
-- Can access all 32 amp models from the front panel - without midi.
With Tap Tempo held down the following dials change:
- Drive - Distortion (on/off)
- Bass - Delay Feedback
- Middle - Delay Level
- Treble - Presence boost (on/off)
- Channel Volume - Drive Boost (on/off)
- Reverb - Reverb Decay
- Effect Tweak - Tap Tempo Speed
- Amp Model - Other 16 amp models
- Effects - Cab models
Amp and effects customization feature was added:
- Ability to store your favorite settings for amps and effects, so that next time you turn the dial, they are how you like them.
- Set an amp model how you like it (or effect).
- Then hold down save and tap tempo (Manual, Tap Tempo, A, and B start to flash)
- Hit A to save the amp settings, and B to save effects settings.
- Next time you move to that amp/effect it will be set how you like it.
- Does not work in manual mode.
Tuning for use with an amplifier
POD can be "tuned" to work with different amp setups...
-- Hold down SAVE while powering up
-- Press UP and DOWN to select:
- A - POD feeding Power Amp and closed back cab
- B - POD feeding Power Amp and open back cab
- C - POD in front of combo/head and open back cab
- D - POD in front of combo/head and closed back cab
|
| POD VERSION 2.1 IS DIFFERENT FROM 2.2 |
Latch mode was added
- Hold down Tap Tempo and Manual at the same time
-- Manual and tap tempo will flash
-- All dials act as if you are holding down Tap tempo
Delay carry-over was removed to allow for Latch mode
- When you switch patches your delay will not carry over, it turns off
|
| POD VERSION 2.2 IS DIFFERENT FROM 2.3 |
Some amp models were slightly changed
- Most noticeably the marshall sims
Some cab models were changed
- Most noticeably the NO CAB sim. Sounds a whole lot better.
|
| ADDITIONAL INFO |
Flextone versions changes are the same as POD after 2.1. But, the Flextone skipped 2.3 and went to 2.4. 2.4 on Flextone is the same as 2.3 on POD.
If you have version 1.x it will cost you about $50 to get the upgrade chip. If you are already at 2.x, you can call Line6 for the latest upgrade chip.
|
